Conventional Fire Alarm Control Panel with 8 Zones CK1008

Introduction:

The CK1000 series conventional fire alarm control panel is a 24 volt , Four, Eight, Sixteen-zone, class B,

conventional fire alarm control panel . Designed exclussively to meet the latest market requirements and future ULC

codes, the highly cost-effective CK1000 series can be used in a variety of low- to mid-sized applications. 

Fetures:

1. Four style B(Class B) Initiating Device Circuits (IDCs).

    -All zones accept 2-wire smoke detectors and any normally-open contact devices.

    -Zone 1- 16 configured as general alarm zones.

2. All circuits are power-limited  and supervised, meeting the latest ULC requirements using fuseless technology.

3. Two built-in, Style Y(Class B) Notification Appliance (Signal) Circuit (NACs)

4. NACs maybe programmed:

    -Silenceable

    -Non-silenceable

    -Auto-silence (programme 5-20 minutes)

5. 1.25 amps of NAC power.

6. 3.0 amps of total system power.

7. Alarm, Trouble and Supervisory, relay output.

8. 24-volt operation.

9. Resettable four-wire smoke detector power @ 500 mA.

10. Non-resetable power @ 500 mA.

11. Integral battery charger capable of charging up to 18 AH batteries ( batteries over 4 AH require use of the external backbox, or ULC listed equivalent).

12. Disable/Enabel control per IDC.

13. Reverse polarity protection.

14. Control buttons:

     -Mode

     -Test

     -ACK( Acknowledge) Alarm Silence

     -Reset

15. LED indicators:

     -AC power( Green and Yellow LED)

     -Fire alarm (Red LED)

     -Trouble (Yellow LED)

     -Supervisory (Yellow LED)

     -Signal Silence (Yellow LED)

     -Battery power (green and yellow LED)

     -Zone Disabe (yellow LED)

     -NAC Fault (yellow LED)

     -NAC Disable (yellow LED)

     -Zone Alarm (one for each zone) (red LED)

     -Zoen Trouble (one for each zone) (yellow LED)

     -Earth Fault (on circuit board)

     -Battery Fault (on circuit board)

     -Charge Fault (on circuit board)

Specifications:

1. AC power

  -90~270VAC, 50 Hz, 2.0 amps.

  -Wire size: minimum 14 AWG with 600-volt insulation.

2. Battery

  -Sealed lead-acid batteries only.

  -Maximum charging circuit: 27.6VDC @0.8 amp for nomal flat charge.

  -Maximum charger capacity: 18AH battery.

 Note: two 4 AH batteries can be housed in the cabinet. Large batteries require a seperate battery box.

3. Total 24 V system power: 3.0 amps.

4. Notification appliance (signal ) power: 2.5 amps.

5. Maximum current per NAC: 1.25 amps ( expandable to 2.5 amps).

6. Maximum battery charging capacity: 18 AH.

 

         

 

Contact Us
	Tel : 02-996-2636 หรือ 02-029-9470
	Mobile : 082-4500417 - 8
	E-mail : sales@pathumdesign.net
	Line ID : @pathumdesign
	Wechat : Pathumdesign
	Facebook Fanpage : Pathumdesign

  

เว็บไซต์ :	www.psshop01.com
	www.pathumdesign.net
	www.cctvsquare.com
	www.isystemsoftware.com
	www.taradcctv.com